|
|
|
| Products > Garden Systems > Ezy Brick > How to build a Bar-B-Que Page 1 |
|
How to Build a Bar-B-Que Steps 1-5
|
|||
|
1.
|
A stable level foundation of 3" concrete is preferred.
Good paving on road base would be
OK. Check that foundation is stable before setting out the
base course. If foundation is not level, you could lay a bed of 10:1 sand
and cement (dry) to level the foundation. Proceed to lay the base course
as per the plan supplied. It is important that the base course be laid
correctly. Important: Before laying the first course, you will need to consider where the gas line comes out of the barbecue. In these photos, we have the BBQ on the left hand side. You may need to reverse this to suit the different types of BBQ available. |
 |
|
|
2.
|
2) Once base course is laid and level, check to make
sure that your project is square. Measure one diagonal.
|
 |
|
|
3.
|
Measure the opposite diagonal and compare the measurements.
If they are within 5mm of each other, you may proceed. If not, you must
adjust the base course until the measurements come within 5mm of each
other.
|
 |
|
|
4.
|
Complete the base course and start the second course.
You can use a rubber hammer to tap bricks into place. These courses are
marked A and B on the instruction sheet.
|
 |
|
|
5.
|
Each brick has a small dimple in one lug on top of the
brick (highlighted by black texta in this photo). Where possible, place
the dimple on top of the dimple on the course below it. This helps to
lock in each brick.
|
 |
|
| Go to steps 6 - 10 | |||
|
|
